EasyManua.ls Logo

Marantz CD-17mkII - Page 4

Marantz CD-17mkII
19 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
English
4
CD TEXT
TEXT
FOREWORD
This section must be read carefully before any connection is made to the
mains supply.
WARNINGS
Do not expose the equipment to rain or moisture.
Do not remove the cover from the equipment.
Do not insert anything into the equipment through the ventilation
holes.
Do not handle the mains lead with wet hands.
CE marking (only /22 version)
This product is in conformity with the EMC directive
and low-voltage directive.
EQUIPMENT MAINS WORKING SET-
TING
Your Marantz product complies with the household power and safety
requirements in your area.
“/22” Version product can be powered by 230 V AC only.
IMPORTANT: (FOR /65 version only)
This apparatus is fitted with an approved moulded 13 Amp plug. To
change a fuse in this type of plug proceed as follows:
1. Remove fuse cover and fuse.
2. Fix new fuse which should be a BS1362 5A, A.S.T.A. or BSI approved
type.
3. Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should be cut off
and an appropriate plug fitted in its place.
If the mains plug contains a fuse, this should have a value of 5A. If a plug
without a fuse is used, the fuse at the distribution board should not be
greater than 5A.
NOTE : The severed plug must be destroyed to avoid a possible shock
hazard should it be inserted into a 13A socket elsewhere.
HOW TO CONNECT A PLUG
The wires in the mains lead are coloured in accordance with the following
code:
BLUE—”NEUTRAL” (“N”)
BROWN—”LIVE” (“L”)
1. The BLUE wire must be connected to the terminal which is marked with
the letter “N” or coloured BLACK.
2. The BROWN wire must be connected to the terminal which is marked
with the letter “L” or coloured RED.
3. Do not connect either wires to the earth terminal in the plug which is
marked by the letter “E” or by the safety earth symbol or coloured
green or green-and-yellow.
Before replacing the plug cover, make certain that the cord grip is
clamped over the sheath of the lead — not simply over the two wires.
COPYRIGHT
Recording and playback of some material may require permission. For
further information refer to the following:
Copyright Act 1956
Dramatic and Musical Performers Act 1958
Performers Protection Acts 1963, and 1972
Any subsequent statutory enactments and orders
ABOUT THIS USER’S GUIDE
Refer to the figures on the pages at the back of this user’s guide. The
callout numbers on the figures correspond to those found in the text.
Some of the operations described in this user’s guide can only be
operated from the remote control unit. In the description of controls,
the names of the buttons which are available on both the main unit and
the remote control unit are enclosed in , and the names of the
buttons which are available only on the remote control unit are
enclosed in .
PRECAUTIONS
The following precautions should be taken when operating the equip-
ment.
GENERAL PRECAUTIONS
When installing the equipment ensure that:
the ventilation holes are not covered.
air is allowed to circulate freely around the equipment.
it is placed on a vibration-free surface.
it will not be exposed to excessive heat, cold, moisture or dust.
it will not be exposed to direct sunlight.
it will not be exposed to electrostatic discharges.
In addition, never place heavy objects on the equipment.
If a foreign object or water does enter the equipment, contact your
nearest dealer or service center.
Do not pull out the plug by pulling on the mains lead; grasp the plug.
It is advisable when leaving the house, or during a thunderstorm, to
disconnect the equipment from the mains supply.
FEATURES
CD-TEXT compatibility.
CD-RW (ReWritable) playback capability.
Latest VAM1201 pickup mechanism.
Digital inputs allowing the unit to be used as a high-performance D/A
converter.
High-performance digital ICs "777 Devices", including the DAC7 1-bit
bit stream type D/A converter, the DF7 20-bit, 8-fs digital filter and the
CD7 digital servo IC.
High audio quality parts including the MARANTZ-original HDAM
circuitry.
Highly rigid, stylish design with extensive use of aluminum blocks.
Stylish wireless remote control unit with aluminum top.

Related product manuals