Marantz CD50n - Page 107

Network Control
Enables network communication in standby power mode.
On
(Default):
Network is on during standby. Main unit
operable with a network compatible
controller.
Off: Suspend network function during standby.
0
When using the HEOS app, use with the “Network Control” setting set to “On”.
NOTE
0
When “Network Control” is set to “On”, the unit consumes more standby power.
AirPlay Setup
This unit supports the “WAC (Wireless Accessory Configuration)” setup
mode of Apple Inc. In the WAC setup mode, use your iOS device (iPhone/
iPod/iPad) to connect to the network. By connecting your iOS device with
this unit, this unit can be automatically connected to the same network.
1. Select “AirPlay Setup” and press ENTER.
0
This unit switches to the WAC setup mode.
2. At the bottom of the Wi-Fi setup screen for iOS devices, select
“Marantz CD 50n” from “SET UP NEW AIRPLAY SPEAKER...”.
0
Make sure the iOS device is connected to the wireless LAN (Wi-Fi)
router.
3. Select a network to connect this device and press “Next”.
4. Follow the on-screen instructions to complete the connection.
0
When connected, “Connected” is shown on the display.
NOTE
0
The firmware version of your iOS device must support iOS 10.0.2 or later.
0
The WAC setup mode lasts approximately 15 minutes. If the setup is not
completed within 15 minutes, the WAC setup mode is canceled automatically. If
you cancel the WAC setup mode manually, press the BACK button.
Contents
Connections Playback Settings Tips Appendix
107
Front panel Rear panel
Remote control
unit
Index