Playing tracks in a specific order
(Program playback)
Up to 25 tracks can be programmed.
1
In the stop mode, press PROGRAM.
“Program” is displayed on the display.
2
Use 0 – 9 to select the tracks.
GExampleH
Track 4 : Press number 4 to select track 4.
Track 12 : Press numbers 1 and 2 consecutively to select track 12.
0
The number you enter is set about 1.5 seconds after you press
the number buttons. To enter a two-digit number, be sure to press
the two number buttons, one immediately after the other.
3
Press p.
Playback starts in the programmed order.
0
The program is cleared when the disc tray is opened or the power is turned off.
0
Press RANDOMs while program playback to enter random playback mode.
When p is pressed during random playback mode, the programmed tracks are
played in random order.
0
When REPEAT r is pressed during program playback, the tracks are played
repeatedly in the programmed order.
o
Checking the order of the programmed tracks
In the stop mode, press j.
The tracks are shown in the programmed order in the display each
time j is pressed.
o
Clears the programmed tracks
In the stop mode, press CLEAR.
The last track programmed is cleared each time the button is pressed.
0
You can also select a track to be cleared by pressing j.
o
Clearing the all programmed track
In the stop mode, press PROGRAM.
Contents
Connections Playback Settings Tips Appendix
67
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
