device group (in Use Mode, you cannot see buttons that have
no RC codes).
7 Switch back to DEL mode and delete the group if it is not a
good match to your component. Repeat steps 4 through 6 until
all of your remote controls have a matching device group.
8 Switch to LABEL mode to relabel each device group (see page
32-34).
9 Switch to MOVE mode to re-order your devices, so that your
home panel is arranged the way you want (see page 39-40).
10 Switch to LABEL mode to personalize the greeting on your
home panel (see page 32-34).
11 Still in LABEL mode, navigate to the DEVICE side of the
RC9200/5200. Relabel any buttons as needed to match your
existing remote controls. Check all of your devices.
12 Switch to LEARN mode and teach the RC9200/5200 all of your
non-Marantz components’ RC Codes (see page 28-32).
13 Switching back and forth between USE and LEARN modes, test
all codes and reteach as necessary.
Note Should you need to delete a command, use the DEL mode. Be
very careful to NEVER delete the navigational tabs; they can
only be restored with a personal computer (see page 52).
14 Switch back to LEARN mode. Teach each Device group the
appropriate Preamp/Receiver Input (source switching) RC
command (see page 30).
15 Congratulations, you have completed the first stage of
customization! Take a well deserved break.
User Guide
19
Customizing Your RC9200/5200
To Next Page
Loading...
