User Guide
4
Installing the Battery Pack
1 Press the latch on the battery cover and remove the battery
cover from the Remote Control.
2 Place the battery pack in the battery compartment.
3 Plug the cable of the battery pack in the connector as illustrated.
4 Place the battery cover back on.
Note Make sure the cable of the battery pack does not get stuck
between the molded interior and the battery cover.
After a few seconds, the Remote Control starts up automatically
and an Introduction screen appears. The Remote Control beeps
twice to indicate that it has finished starting up.
Because the battery pack of the Remote Control is not fully pre-
charged, you will have to charge it as described below.
Introduction
To Next Page
Loading...
