Why can't DTS sources be played on my Marantz Receiver?
If DTS sources cannot be played on your Marantz Receiver, it could be because the surround mode is set to DOLBY. Select another mode. It could also be that the DVD or LD player is not DTS digital out capable, so use a player which responds to DTS-digital out.
Why does my Marantz Receiver player skip during play of a DTS source and produce noise?
If the player skips and produces noise while playing a DTS source on your Marantz Receiver, it may be due to a data error during the player skip. Set the Surround mode to DTS-cinema or DTS-music to resolve this.
Why can't a 96kHz PCM signal be played on my Marantz Receiver?
If a 96kHz PCM signal cannot be played on your Marantz Receiver, it could be that the disc player is not 96kHz PCM digital out capable. Use a player that responds to 96kHz PCM digital out. Another reason could be that the surround mode is set to other than STEREO and AUTO. Set Surround mode to STEREO or AUTO.
To Next Page
General