Marathon Calgary - Time Setting

EN
polarity (+ and -). (Note: When the clock is rst
powered by the batteries, all of the segments
of the LCD will display. The clock will then enter
into normal time mode display and beep once.
This is normal.) It is time to change the batteries
when the low battery power indicator appears
on the LCD display above the seconds.
TIME SETTING
TO SET THE CLOCK:
1. Press and hold MODE button on the back of
the clock for approximately 3 seconds until the
 hourisashingontheLCDdisplay.
2. Use the
/
buttons to set the desired hour.
3. Press the MODE button again and the minutes
 willashonthedisplay.
4. Use the
/
buttons to set the
desired minutes.
5. Press the MODE button again to change the
year, month, date, 12/24 hour format.
6. Press MODE one more time to exit
manual settings.
DATE RECALL
1. Press the MODE button on the back of the
clock to switch the display to show the date.
ALARM SETTING & SNOOZE FUNCTION
TO SET THE DESIRED ALARM TIME:
1. Press MODE button twice to enter alarm
setting. You will see “AL” in the lower right
corner of the display.
2. While in alarm mode, press and hold the
MODE button for approximately 3 seconds
 untilthehourisashing.Usethe
/
buttons
to set the desired alarm hour.
3. Press MODEagainandtheminuteswillash.
Use the
/
buttons to set the desired
alarm minutes.
4. Press MODE button again to exit alarm mode.
5. Once you have the alarm time set, you will see
in the top left corner. You can turn the alarm
on/off by pressing the
button when the
clock is in normal display mode.
6. The alarm will ring for 2 minutes before
shutting off automatically. Stop the alarm by
pressing any button except SNOOZE.
7. Press SNOOZE to enter into snooze mode for
5 minutes.
8. The clock will display Zz when snoozing. You
can snooze up to 8 times. Press any other
button except SNOOZE to turn alarm ring off.
PRECAUTIONS
•
Do not clean any part of the clock with
benzene, thinner or other solvent chemicals.
When necessary, clean it with a soft cloth.
•
Never immerse the clock in water. This will
damage the clock.
•
Do not subject the clock to extreme force,
 shock,oructuationsintemperature
or humidity.
•
Do not tamper with the internal components.
•
Do not mix new and old batteries or batteries
of different types.
•
Do not mix alkaline, standard and rechargeable
batteries with this clock.
•
Remove the batteries if storing the clock for a
long period of time.
•
Do not dispose of this clock as unsorted
municipal waste. Collection of such waste
separately for special treatment is necessary.