2
Installation
Adequat air circulation should be around the appliance to prevent overheating. Please Keep at least 2'' on both sides and
top of the refrigerator for ventilation, easy access and removal of shelves.
• Wherever possible the spacers of the product should be against a wall to allow for proper ventilation and
to prevent contact with warm parts such as the compressor or condenser.
• The appliances must not be located close to radiators or cookers.
• Make sure that the main plug is accessible after the installation of the appliance.
WARNING! The electrical outlet must be easily accessible after installation in the event you need to
disconnect the refrigerator from the main power outlet.
Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your power supply.
The appliance must be ''grounded'' and the power cord plug is provided with a ''ground'' for this purpose.
If the power supply socket is not ''grounded'', connect the refrigerator to a separate ''ground'' in compliance with local and
Federal regulations after consulting a certified electrician. The manufacturer declines all responsability if the above safety
precautions are not observed. This appliances complies with the E.E.C. Directives.
Rear Spacers (if supplied)
• Install the rear spacer at the rear of the
appliances to provide ventilation
Levelling the Refrigerator
• Adjust the two levelling feet at front of the
Refrigerator. If the refrigerator is not level,
the door may not close and seal properly.
MAR45W/MAR45BLS
To Next Page
Loading...
