To Next PageTo Next Page
Need help?Do you have a question about the Marco BM36HCD and is the answer not in the manual?
Safety requires installation per manual; non-Marco components pose fire hazards.
Crucial for safe operation; consult local building codes; grounding is recommended.
Maintain structural integrity and use the firestop thimble through the roof cavity.
Avoid restricted areas; air inlet ducts must not terminate in attic spaces.
Assemble outer pipe, flue pipe, and wire spacer for chimney sections.
Fit inner pipe into fireplace starting collar, ensuring full insertion for locking.
Fit outer pipe over starting collar, aligning slots with wire spacer locks.
Crucial warning not to pack required air spaces with insulation or other materials.
Install thimble through ceiling/roof cavity, ensuring zero clearance to combustibles.
Seal around outside air, gas line, and "J" box; insulate gaps and cracks.
Do not use blown-in insulation; prevent contact with required air spaces.
Test all gas connections with soap suds; never use an open flame.
Operate doors fully open or closed; avoid partial opening for safety.
Operate damper fully open; never close to reduce a large fire to prevent smoke hazards.
General| Model | BM36HCD |
|---|---|
| Fuel Type | Natural Gas or Propane |
| Heat Output | Up to 36, 000 BTU |
| Vent Type | Direct Vent |
| Ignition Type | Electronic Ignition |
