Marco FILTRO SHUTTLE 5.6kW

To Next Page

mar coO

FI LTROSHUTTLE

MAINTEtiANCE:

Marco macnines have been designed to give many years of trouble free service.

Marco Beverage Systems design, manufacture and test to IS09001 :2000 standard.

The only regular ~aintenance required is occasional de-scaling.

In common with all water boiler manufacturers, service calls resulting from

limescale are not covered by warranty. Fitting a scale reducer is recommended,

especially in hard water areas. This can reduce the build-up of scale but may not

stop it altogether.

A service agent should descale the machine regularly. The frequency that

descaling is required depends on the local water supply; hard water areas need

more attention. Marco suggest that the machine be descaled every 3 months if the

unit is in a hard water area. In soft water environments every 6 months should

suffice.

CLEANING:

POURING

PERFECTION

Lil,e any :-:ooking utensils the coffee urns of your Filtro Shuttle must be cleaned

properly

8,.,rj regularly. Marco recommend cleaning after each days brewing using a

ProPI;etar . urn-cleansing compound.

MareI'

u", -::Ieans~"r(Marco Part number 8000240) is available in 800g tubs.

Instn'st... ., are givt:n~n each tub.

The e\ renul of these machines may be cleaned with a damp cloth and a light

dete'

]8;'1 Do not use abrasive cloths or creams, as this will spoil the finish of the

machh:; Do not use a water jet or spray. Beware of accidentally operating the

draw off

t"JP when cleaning the front of the machine.

URNS:

The

Ftro Shuttle is designed to accommodate the Marco urn

Parr

nurnl-,e: 1700174 Insulated Urn 6L Shuttle

INSTRUCTIONS FOR MODELS

FILTRO SHUTTLE 5.6~(VJ

(PIN: 1000650)

FILTRO SHUTTLE 2.8kW'

(PIN: 1000651)

Water Pressure: 5 - 50 psi (min.-max.)35 - 345 kPa (min.-max.;

Water Flow Rate: 1.5Litres per minute minimum

! MARCO h~::11

1509001 :2IJ!J,;

Registered

Cornpar,y

(i)

~ ~~(.'\~~ooo~

Marco Beverage Systems Limited.

63d Heather Road,

Sandyford Industrial Estate,

Dublin 18

Ireland Tel: +353 (0)1 2952674

lieland Fax: +353 (0)1 2953715

email: sa1es@marco.ie

www.f!11Jr;;o.ie

Marco Beverage Systems Limite::!.

Shire House, Strixton Manor

Strixton, Wellingborough. No:than:;;

NN29 7PA

________________ J

UK Tel: +44 (0)2072 744 577 ;

UK Fax: +44 (0)2079 788 141

email: sales@rnarcc-hp.v ..:.- Jk

www.marco-bev.co.uk

--- -- -~.-. --_ ..."...-------

Instructkp :iU·:'i 2;1Filtro Shuttle 29-J3-07.doc

Page 8 of 8

I 1.,_. __--

Need help?

Do you have a question about the Marco FILTRO SHUTTLE 5.6kW and is the answer not in the manual?

Summary

Maintenance and Cleaning

Descaling Procedures

Details on descaling frequency based on water hardness and recommended intervals.

Daily Cleaning Instructions

Guidance on proper cleaning of coffee urns and exterior surfaces using specific compounds.

Urn Compatibility

Information on accommodating the Marco urn and its part number.

Model Information

Filtro Shuttle 5.6 kW

Details for the 5.6kW model, including part number.

Filtro Shuttle 2.8 kW

Details for the 2.8kW model, including part number.

Safety Warnings and Troubleshooting

Flooding and Plumbing Hazards

Warnings about flooding risks during brewing and proper plumbing installation.

Scalding and Electrical Safety

Precautions regarding hot water dispensing and electrical installation requirements.

General Service and Maintenance Precautions

Emphasis on following manufacturer instructions for safe operation and maintenance.

Diagnostic Flash Codes

Explanation of the electronic diagnostic system and error flash sequences.

Low Water Pressure Troubleshooting

Specific guidance for 2 and 6 flash errors related to low water pressure.

Installation and Setup Procedures

Electrical Installation Requirements

Specific electrical connections for 2.8kW and 5.6kW models.

Plumbing Installation Steps

Instructions for connecting water supply, including pressure and flow rate.

Initial Start-up Sequence

Steps from initial checks to the machine being ready to brew.

Machine Operation Overview

Heat Fill Cycle Explained

Description of the standard heat-fill cycle for water heating.

Brew Readiness Indicator

How the Ready To Brew LED indicates the machine is ready for brewing.

Control Panel Functions

Overview of control panel LEDs, Lock function, and brew selection buttons.

Brewing Coffee Guide

Filter Paper and Coffee Preparation

Instructions for preparing the filter paper and adding ground coffee.

Urn Placement for Brewing

Ensuring correct urn alignment for optimal coffee decanting.

Brew Selection and Timing

How to select half or full brew and expected brewing times.