Marco UP3/E - Product Description and Specifications; Technical Specifications Table; Applications and Fluid Compatibility; Allowed Fluids and Dangers

© S.p.A.
PRODUCT DESCRIPTION
TECHNICAL DETAILS
APPLICATIONS
FLUIDS ALLOWED / NOT ALLOWED
ENG
Main use as automatic pump for freshwater and sanitary water systems on boats, vans and
RV.
There are numerous fields of applications for the pump, however only exclusively with the
allowed liquids mentioned:
Self-priming gear pump, integrated check valve and electronic pressure sensor: to be used
as automatic pump for water systems. Nickel-plated brass body, PTFE gears, stainless-steel
shaft and lip seal. The electronic pressure sensor is preset at 2,5 bar.
13
Tab.2 EN
FRESH WATER (max 40 °C)
PETROL (GASOLINE)
•
FLAMMABLE LIQUIDS with PM< 38 °C
•
LIQUIDS WITH VISCOSITY > 20 cSt
•
CORROSIVE CHEMICAL PRODUCTS
• •
SOLVENTS
• •
LIQUIDS DANGERS
WARRANTY EXPIRES IF MAX FLUID
TEMPERATURE IS EXCEEDED
FIRE / EXPLOSION
MOTOR
OVERHEATING
PUMP CORROSION
DAMAGE TO SEALS
OK
NO
ISO 8846 Compliant Device
INJURY TO
PERSONNEL
Tab.1 EN
CODE TYPE VOLT
l/min 15 bar 2,5 m 1,5 kg 2 mm² 1,5
gpm 4,0 psi 36,3 ft 4,9 lb 4,4 AWG 16
IP 67 Protection
(*) Internal tube Ø 13 mm / (**) Length up to 2 m
A164 602 15 12/24V 15
WEIGHTPRESSURE WIRE SIZE (**)FUSE FLOW RATE (*)
UP3/E
SELF-PRIMING