STEP 3 (See Diagram 3)
A.) Attach the Front Press Base (#2) to the Upper Frame (#1). Secure it with one 6
¾” Front Press Base Axle (#29), two Ø 1 ¼” Washers (#59), and two M10
Aircraft Nuts (#91).
B.) Attach the Front Press (#3) to the Front Press Base (#2). Secure it with one 7
½” Front Press Axle (#30), two Ø1 ¼” Washers (#59), and two M10 Aircraft
Nuts (#91).
C.) Thread the T-shaped Lock Pin (#39) into the hole on the Front Press to obtain
the desired Front Press position.
D.) Attach the Backrest Board (#31) to the Backrest Support Frame (#5). Secure it
with two M8 x 1 5/8” Allen Bolts (#86) and Ø 5/8” Washers (#88).
E.) Attach the Backrest Support Frame to the Vertical Frame (#4). Secure it with
one M10 x 4 3/8” Allen Bolt (#80), two ∅ ¾” Washers (#92), and one M10
Aircraft Nut (#91).
F.) Thread the Long T-shaped Lock Pin (#38) into the hole on the side of the
Vertical Frame to obtain the desired Backrest position.
10
To Next Page
Loading...
