MARIMEX Florida - Habitat Selection Guidelines; Pool Assembly Procedures

23
the labelling of chemical products and follow them.Educate the bather to drink
water and avoid possible nausea.Observe the principles ofhygiene.
Guidelines for the selection ofhabitat
• Thispoolisdesignedforoutdooruseandis notintendedforinsertioninto theof
the country.
• Yourswimming poolis afragileproductandcanbeeasilydamaged.Payattention
thereforethe selection ofsitesfor thepool.
• AreaforpoolmustbeHORIZONTALandfixed.Failure to comply withthissecti-
onmaycausethatthepoolcrashes.
• The swimming pool must be installed on a solid, smooth and horizontal surface on
land that is free of stones, gravel pits, bitumen or other oil-based compounds.Do
not install the pool on a wooden base or grid, on the terrace, balcony, etc.
• Avoid locations under the overhead power lines or in the proximity of the tre-
es, or that is located approximately 3 metres of the House, buildings, patios,
etc.Also, make sure that the place of installation that you selected,there are no
underground areas (sinks, septic tanks, etc.) andthere are no cables, telephone
lines, gas pipes, etc.
• This place must also be at least 3.5 m from the mains power supply of the electri-
cal circuit used, which corresponds to a valid filtrationCSNandthatmustbeequi-
pped witha residual currentdevice(RCD)with a trippingcurrentnot excee-
ding30mA.
• If possible, choose a location on your property with direct sunlight.It helps to
heat the water in your pool.After the beginning of the filling of the pool anywhe-
redo not drag.
• Select the site for the pool, so that if there is an accident or damage to the
pool water coulddrain away without problems,withoutwouldendangerpeop-
leandanimalsordamagedbuildingsorland.
Failure to comply with the instructions given in this manual can lead to the
collapse of your pool and void the warranty!
Assembly instructions forthe pool
After careful selection of a suitable location for the pool, carefully remove all dirt
from it, twigs, stones, etc.To continue with the installation by followingthe in-
structions.
• For an Assembly, it is recommended the participation of at least two adultpeop-
le.
• Now expand the pool carefully and place it on the ground.Pool place co-
rrectly.Pool pull, they may tear or otherdamage.
• Carefully spread layout pool sides and bottom to pool on the day if possible as
smooth as possible, formed a circleanditsconnectionfittingswasorientedtothe
pointwhereit will beplacedthe filterunit.
Tip: the installation will be much easier when you unfold it and leave the pool to
lie in direct sunlight for about 2 hours before you install.This will help to make
the crease-free, because the material of the pool will be much poddanější, and
EN