MARIMEX Florida - Page 24

24
stretches more easily during the installation to the regular shape.
Recommendation: Insert under the bottom of the pool of suitable textile pad;to
better protect the oor from damage.
• Split the supplied‘s pipes, T-connectors, and other components.The shorter
the pipe with a larger diameter and a pair of holes in the ends of the beams are
horizontal (91).Longer pipes with smaller diameter and exible fuse (95) are
the vertical struts (94).Take the horizontal beams (91) and slide it into the slee-
ve at the top of the walls of the pool.Turn the beam so that the holes in their
ends were ush with the wall.Gradually the beams around the perimeter of the
pool to connect by using the T-connectors (92), the holeswouldhaveto worry
aboutin theoccultation.So far thejointsdo not apply tapeusingdovetail jo-
ints(93).Seefigure1and2.
• As soon as you complete theinstallation of thelastT-couplers,install thepi-
vots(93)with thedeployedsealingrings(97)–seefigure3.
• As soon asit isbuiltandsecuredthe topframe,position theverti-
calStruts(94).Ononeend of theverticalStrutsispre-installed catch-this end
include up to the T-coupling.First, insert the vertical strut (94) between the wall
of the swimming pool and the belt located in the central part of the walls (see fig.
4).The top of the Struts slide into the appropriate T-connectors (92) and turn the
brace in order to secure the position with a exible policy.Finally, attach the strut
to the bottom of the presser foot (96) and both parts into each other to push to
the limit.
• Follow around the perimeter of the pool and install all the vertical struts.Make
sure that you are correctly deployed the presser foot (96) and secured connecti-
ons with T-connector using exible insurance policies.Then drag Struts for lower
end and gently pulltowards theoutfromthe Center,in order toremainverti-
calandconsisted ofregularcircle.
• Make sure that the drain plug pool closed and start with the performance of the
pool water.After filling, approx. 3 cm water stop water and smooth the bottom
of the pool from all the folds on the bottom of the pool.This can be done by
extrusion from the middle to the edges, where it meets the wall to the day of the
swimming pool;or grabbing from the outside the place where the wall meets the
day and drag outward. Then he will fulfill pool evenly and maintain their shape.In
case of problems with the shape of the bottom pull in two people against each
other and remove all creases.Note: If before the beginning of the performance at
any point, collects the dna of more than 3-5 cm of water, than in its Center, there
is a swimming pool in the plane, and must bedrained, desktop or choose another
and start the whole process again.Note: the weight of the water will not allow to
continue building according to the following points.
• Stopfillingthe pool.Assembleandattach thefilterunittothe pool.Seesepara-
teinstructionsforuseandinstallation the pump.
• After you install the filter pump to continue with the fulfilment of the pool.It is
advisable to check the pool periodically during the implementation to make sure
that it is filled evenly.To continue with the fulfilment of water until it reaches a
level to the mark on the inside wall of the pool and the pool wall is smooth and
firm.
Do not overfill the pool above thistag.