MARIMEX ProStar PLUS 2 m3/h

Questions and Answers

B
Brendan MontgomeryAug 5, 2025
How to fix low water flow in MARIMEX Water Filtration Systems?
- C
  Christopher RamirezAug 5, 2025
  If you're experiencing low or no water flow in your MARIMEX water filtration system, there are several possible causes. First, ensure the filtration assembly is properly bled. Next, check that the valve lever is in the FILTRATION position, not CLOSED. If the sand is too contaminated, perform RINSING or replace the sand. Also, check for a clogged pre-filter or skimmer; dismantle and rinse them if necessary. If none of these steps work, the filtration assembly might be damaged, and you should contact a service centre.
L
Laura LewisAug 11, 2025
Why MARIMEX Water Filtration Systems can't clean the pool water?
- A
  Angel CohenAug 11, 2025
  If your MARIMEX water filtration system isn't cleaning the pool water effectively, it could be due to insufficient chemical treatment. Check the pH value and chlorine content of the water. Alternatively, the filtration time might be insufficient; try extending it to see if that improves water clarity.
J
James YatesAug 16, 2025
What to do if MARIMEX Water Filtration Systems pump sucks air?
- T
  Thomas AlexanderAug 17, 2025
  If the pump in your MARIMEX water filtration system is sucking air, causing bubbles in the system, check for insufficiently tightened joints and gently tighten the cap nuts. Also, inspect the pre-filter connections for leakage and repack the joints if necessary. Finally, check the seals in the connections 'in front' of the pump for any damage.
J
Jason BakerAug 23, 2025
Why does sand penetrate the pool from MARIMEX Water Filtration Systems?
- D
  David MooreAug 23, 2025
  If sand is entering your pool from the MARIMEX water filtration system, it could be due to handling the valve lever while the filtration unit is running; always turn off the unit and wait about half a minute before handling the lever. Another cause may be the small grain size of the filter sand; the recommended grain size is 0.6 - 1.2 mm. Finally, a high level of sand in the container could be the issue; reduce the amount of sand.
P
portermakaylaAug 29, 2025
How to fix water leakage from MARIMEX Water Filtration Systems?
- C
  Charles DavisAug 29, 2025
  If you notice water leaking from your MARIMEX water filtration system, start by checking for leaking joints and tighten or repack them. Also, inspect the seals for any damage.