Marina-Speroni PMC 5 Operating Instructions

65 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

Инструкция

по эксплуатации

Поверхностный самовсасывающий насос Marina-Speroni

CAM 88/CR

Цены на товар на сайте:

http://nasosy.vseinstrumenti.ru/poverhnostnye/samovsasyvayushhie/marina/cam_88cr/

Отзывы и обсуждения товара на сайте:

http://nasosy.vseinstrumenti.ru/poverhnostnye/samovsasyvayushhie/marina/cam_88cr/#tab-Responses

Table of Contents

Other manuals for Marina-Speroni PMC 5

Questions and Answers:

R
Rachel GriffinAug 8, 2025
Why Marina-Speroni PMC 5 motor will not start?
- M
  Melissa GutierrezAug 9, 2025
  The Marina-Speroni Water Pump motor might not start due to several reasons: * There may be no mains voltage, in which case you should check the voltage. * The pump impeller could be jammed. If so, dismantle the hydraulic section and check if the impeller rotates freely, then carefully reassemble. * The thermostat might be detached. In this case, dismantle the hydraulic section and check if the impeller rotates freely before carefully reassembling.
A
Amanda DurhamAug 13, 2025
What to do if Marina-Speroni PMC 5 Water Pump will not suck?
- S
  Shane WilsonAug 13, 2025
  If your Marina-Speroni Water Pump isn't sucking, consider these potential causes and solutions: 1. Ensure the suction valve is submerged in water, at least 30 cm deep. 2. If the pump chamber is without water, pour water into the suction union. 3. Check the suction pipe to ensure it is airtight. 4. Clean the suction valve if it's not airtight. 5. Clean the suction rose if it's dirty. 6. Verify that the maximum suction lift hasn't been exceeded.
J
josegrahamAug 18, 2025
How to fix insufficient rate of flow in Marina-Speroni PMC 5 Water Pump?
- L
  leejeanAug 18, 2025
  An insufficient flow rate in your Marina-Speroni Water Pump could be due to several factors: * A suction lift that is too high. Check the suction lift. * A dirty suction rose. Clean the suction rose. * A water level that falls quickly. Set the suction valve lower down. * A pump flow rate reduced by foreign bodies. Clean the pump and replace any worn parts.

Marina-Speroni PMC 5 Specifications

General

Brand	Marina-Speroni
Model	PMC 5
Category	Water Pump
Language	English

Related product manuals

Marina-Speroni RSM 5 GA

Preview: Marina-Speroni KS 801 P

Marina-Speroni KS 801 P

Marina-Speroni CAM 98 CRFT

Marina-Speroni CAM 100 HL