Marineland Eclipse - Lighting Maintenance

16 17
1.Unplug Light and Pump. NEVER change
lamps while power is on.
2.Lift Light Housing.Using a screwdriver,
rotate Lens Cover Fasteners a single
quarter-turn to the stop.Fasteners remain
in Lens Cover (Fig.17).
NOTE: Eclipse
3
has three fasteners.
Carefully remove Lens Cover by lifting
up and off.Set aside.
3.Remove lamp.Grasping each end,gently
twist 90° and pull forward and out from
housing sockets (Fig.18).Discard.
4.Replace discarded Lamp(s) with new
Lamp(s) (see page 6).
5.Replace Lens Cover.Rotate Lens Cover
Fasteners (1/4 turn clockwise) to secure
cover in place.
LIGHTING
LIGHTING
Illumination is provided by a daylight full spectrum fluorescent lamp,selected
for truest color rendition and live aquatic plant growth properties.Over time,
lamp performance will decline.We recommend replacement after 5,000 hours
or 12 months of use.See your dealer or call Marineland Customer Service to
obtain Eclipse replacement lamps.
C
A
U
T
I
O
N
Handle hood with dry hands only.Water can seep into
lighting vents in hood and damage electrical components.
Do not attempt to remove white Access Housing
from mounting.To do so may cause electric shock
and severe injury.
FIGURE 18
Lamp
MAINTENANCE DATE MAINTENANCE DATE
MAINTENANCE LOG
MAINTENANCE LOG
Clean equipment works best.Record the maintenance performed and the
date below.Regular care keeps your unit operating at peak efficiency.
FIGURE 17
Lens Cover
Fasteners
Lens
Cover