Need help?Do you have a question about the Mariner AQA430SL and is the answer not in the manual?
Connect amplifier ground to vehicle chassis for noise reduction.
Connect to battery positive terminal via fuse for amplifier power.
Connect to car stereo remote output to turn amp on/off.
Identifies controls and inputs on the front of the amplifier.
Identifies power, speaker, and remote terminals on the rear.
RCA and Hi Input for connecting audio sources.
Adjust amplifier sensitivity to match source signal voltage.
Select full pass, low pass, or high pass filtering with frequency adjustments.
Terminals for connecting speakers or subwoofers.
GND, Remote Turn On, and +12V Power terminals for setup.
LED indicator for status and fuse for protection.
Power Output| maximum power output | 1600W |
|---|---|
| power output at 4 ohm | 300W x 4CH |
| power output at 2 ohm | 600W x 4CH |
| bridged power at 4 ohm | 1200W x 2CH |
Audio Specifications| total harmonic distortion | 0.05% THD+N |
|---|---|
| frequency response | 20Hz-40KHz |
| high-pass filter | 50-500Hz |
| low-pass filter | 50-500Hz |
| adjustable sensitivity range | 180mV - 6V |
| input impedance (low level) | 18k |
Physical Specifications| fuse | 40A |
|---|---|
| dimension (HxWxL) | 1.73 x 6.22 x 8.03 inches |
To Next Page