Need help?Do you have a question about the Mark-10 DC4040 and is the answer not in the manual?
General| Brand | Mark-10 |
|---|---|
| Model | DC4040 |
| Category | Controller |
| Language | English |
Details the placement and securing of the controller in the work area.
Provides instructions for connecting the power plug and controller cable.
Explains how to connect the controller to the test stand.
Instructions for connecting the power cord and safety checks before powering on.
Immediately stops motion and disables the test stand until reset.
Sets or changes the access password for parameter setup.
Details how to set independent speeds for both directions of movement.
Explains the auto return feature, where the stand moves to a limit, reverses, and moves to the other limit.
Configures the number of cycles for automated test sequences.
Sets individual clockwise and counter-clockwise travel limits for TSTM/TSTMH stands.
Sets the percentage of full scale at which test stand travel stops due to overload.
Resets all parameters to their factory default values.
Allows setting a password to prevent unauthorized parameter changes.
Introduces the three primary operating modes: Basic, Auto Return, and Cycling.
Manual control of test stand movement using UP/DOWN buttons.
Test stand moves to a limit, reverses, and moves to the other limit.
Test stand cycles between limits with pauses at each limit.
Test stand is controlled via serial communication with a computer.
Immediately stops motion and requires reset to resume.
Details controlling the test stand via computer using ASCII commands.
Lists technical specifications for the Series DC digital controllers.
To Next Page