6
Place the goods down with care, avoiding sudden movements or, worse, dropping the goods.
IT IS ABSOLUTELY FORBIDDEN to station under suspended loads and inside the movement area
of the lifting equipment.
When handling the units, use suitable means according the weights involved, as envisaged by EC
Directive 89/391 and subsequent amendments.
Lifting must only be carried out by qualied personnel.
2.3 Unpacking the equipment
Free items from the packaging material and collect the packaging to avoid potential danger of re and
suffocation of persons or animals.
Leave the machine on its packaging base until the installation to avoid damages.
Disposal of packaging materials must be conform to the regulations in force in the country of
destination where the evaporative cooling unit is installed.
2.4 Storage
During transportation and storage, make sure that the environmental temperature is between -10
and 50 °C. If the ColdStream evaporative cooling unit must be stored, make sure that the relative
humidity in the warehouse is between 5% and 90%.
3.0 Positioning and installation
3.1 General warnings
Before proceeding to install, make sure that each evaporative cooling unit has been unpacked and
checked for damage.
Positioning and installation of the evaporative cooling units must be carried out by qualied
personnel and by observing the laws in force in the country of destination.
3.2 Roof installation
Prepare and x an air inlet anged duct. The ange has to be of the
same dimension of the unit’s trunk duct ange.
The unit is equipped with a trunk of anged duct that will be xed to the
ange of the inlet duct prepared before.
3.2.1 TA Evaporative coolers
Position the evaporative cooler base to the inlet duct and x the two
anges (base duct ange-inlet duct ange) together by using provided
bolts.
It is recommended to insert some silicon paste between the two
anges to guarantee perfect insulation from external agents.
!
!
!
!
To Next Page
Loading...