7
markilux.com
2. Awning with hand crank operation
markilux Vertical Blinds & Awnings
Operation manual
1. Reading the instructions
Attention!
Read the operating instructions and all the documentation pertaining to the product (handover protocol), important
guidelines, etc.) carefully and completely before using the product.
1. Engage the hook of the crank rod in the transmission eyelet.
Turn the crank rod until the driving pin engages in the
bayonet closure.
2. Hold the crank rod with one hand on the upper and one
hand on the lower turning handle. During the operating
procedure, pull the crank slightly towards the operator.
3. If the transmission eyelet is on the right side (as illustrated):
• Extension of the awning cover: Counterclockwise rotating of
the crank.
• Retracting the awning cover: turn the crank clockwise.
• If the transmission eyelet is at the le side, the directions of
rotation are precisely the opposite.
4. Aer retraction and extension respectively, remove the hand
crank from the gear by slightly pushing it upwards and
turning it and keep in a safe place.
5. If the crank rod is to be le in the transmission eyelet, it must
be secured against uncontrolled movements (e.g. during
wind)!
Tip: If the extended fabric is not under tension, because the
fabric had been unwound too far, push the awning inwards
until the fabric tension is reached again.
2.1 Standard manual operation - outside operation
To Next Page
Loading...
