9
markilux.com
STOP
Protection against overheating:
Multiple extension and retraction of the awning in rapid
succession results in an automatic motor switch-o to
preserve it from overheating. Aer cooling down the motor
switches itself on again in operating readiness.
4. Conversion or retrofitting
The following modifications can be carried out retrospectively on your awning by your markilux specialist.
• Replacement of the awning fabric
• Installation of a motor
• Retrofitting an automatic control system. In principle a motor drive must be available. Ask your specialist retailer about sun
and wind sensors, remote control etc.
5. Safety note
Attention - risk of injury!
The folding arms of the markilux 730 / 830, 740 / 840 and 745 /845 generate very high compressive stress on the front profile
and the fabric of the awning. This compressive stress is generated by tension springs, which are located within the folding arms.
Because of the accident prevention regulations, these gas pistons must not be dismantled, opened (e.g. by drilling), forcibly
damaged or heated over 80°C. The gas pistons contain oil and must be disposed of only through the raw materials trading
sector or a hazardous waste collection site.
In case installation works to your awning are necessary, these have to be carried out only by a markilux expert!
6. Awning with extendable standpipes (markilux 730 / 830)
1
2
4
5
3
6
Attention: From time to time kindly check the stability of your 730 / 830, if it is
mounted at extendable standpipes. If required, the thread has to be adjusted with the
SW threaded screw at the foot plate.
1 Vertical column 4 Stopper
2 arm fixture 5 Hexagonal screw SW 19
3 star knob 6 base plate
To Previous Page
Loading...
