Markilux 8800 tracfix - 4. What to do if the awning has no tension in the middle position?

17
www.markilux.com
5. The course taken by the drive belt



















4. What to do if the awning has no tension in the middle position?
19
23
2
By pulling the drive belt (19) out of the guide track (2), bring
the hole in the internal gas piston into convergence with that
of the guide track and re-insert the split-pin (23) (on both the
right and the left). The drive belts are now now longer under
tension and the gas pistons are held securely in position. Now
tighten the drive belts as described in chapter 3, paragraph 21
and tension the awning again as in paragraph 22.
5 = cassette
12 = belt roller
18 = fabric roller
19 = drive belt
20 = projection prole