EasyManua.ls Logo

marklin 6646 - Short Circuit and Overload Protection; Troubleshooting Guide; Other Information; Polarity Check for Track Circuits

marklin 6646
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
4. Short Circuit or Overload on a Transformer
Abuilt-inthermalswitchprotectstheTransformerfrom
damageincaseofanoverloadorashortcircuit.Locomo-
tivesonthelayoutwillcometoastop,accessoriescannot
beoperatedandalllampsconnectedtotheTransformerwill
goout.
The following procedure is recommended:
1. Unplugthepowercordsforalltransformersfromtheir
outlets.
2. Lookforthecauseoftheshortcircuitonthelayoutand
correctit.
3. Afterabout1minutethethermalswitchwillgobackto
beingon.Afterthisamountoftimehaspassed,allTrans-
formerscanbeplacedinoperationagain.
IftheTransformershouldshutoffagainandyouareunable
tolocateashortcircuit,thentheTransformerisoverloaded.
InthiscasethenumberofusersconnectedtotheTransfor-
mermustbereduced.
Other Information
AllMärklinproductsasdeliveredconformtotherelevant
regulationsonpreventinginterferencewithradioandtelevi-
sionreception.Wornoutmaterialsand/orfaultymainte-
nanceoftheproductaswellasoperationnotinaccordance
withtheinstructionscanleadtoincreasedinterferencewith
radioandtelevisionreception.Aninformationsheetonthis
subjectisavailableonrequest.
Thewiringdiagramsthatapplytothedifferentturnoutsor
signalscanbefoundintheinstructionsthecomewiththese
products.
Checking the Polarity
Whentwoormoretraincontroltransformersfordifferent
trackcircuitsareusedonalayout,itmayhappenthat
differentpolaritiesforthetransformersmaycauseastrong
sparkonthepickupshoeofalocomotivepassingoverthe
separationpointbetweentwotrackcircuits.Inthisinstance
theplugonthepowercordforoneofthetransformersmust
beremovedfromitsoutlet,turned180°andpluggedback
intotheoutlet.

Related product manuals