EasyManua.ls Logo

marklin 76495 - Intended Use of the Product; Safety Notes; Technical Data; Functions

marklin 76495
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
Intended Use of the Product
•
ThissignalisforinstallationonH0digitalmodelrailroadlayouts.
• Thissignalmayonlybeusedforanalogoperationwiththe
72760controlbox.
• Useonlyinenclosedareas.
Contents as Delivered
1 Signal
1 Decoder with mounting plate
1 Cable with plug, 2-conductor, red and brown
1 Cable with plug, 3-conductor, red and red
1 white and violet wires with 2-pin plugs for plugs
1 Cable with plug, 3-conductor, violet, red-green, red-braun
1 K Track base with a cover
1 grade wedge
1 cover for below-baseboard installation
1 screw 2 x 10 mm
2screws2.5x20mm
4 Insulator sleeves (red) for C track (1 sprue)
2 Center conductor insulators (gray) for K Track
1 Center conductor connector for K Track
1 Set of decals for identification
Installation instructions
Warranty card
Safety Notes
• IMPORTANT! The product has sharp edges and points due to
thewayitworks.
• Dowiringandinstallationworkonlywhenthereisnovoltage
present.Failuretoadheretothismaycauselife-threatening
currentandinjury.
• This signal is to be operated only with the permissible
voltage (seetechnicaldata).
Important Notes
• Theoperatinginstructionsareacomponentpartofthe
product and must therefore be kept in a safe place as well as
fortransferoftheproducttothirdparties.
• Thesignalmastsforthe76395/76397signalscannotbeused
withthiselectroniccircuit(decoder).
• PleaseseeyourauthorizedMärklinspecialtydealerforrepairs.
• Disposingoftheproduct:www.maerklin.com/en/imprint.html
Technical Data
• Voltagesupply 16-20V
• Load 100 milliamps
• Loadatthetrackoutput max.2amps
• Electricalstrength max.40volts
Functions
• Capableofmulti-protocols:fx(MM),mfx*,andDCC
• ModeofoperationsetbymeansofDIPswitches
• AddressescanbesetbymeansofDIPswitches:
1-256 fx (MM) (Control Unit 6021)
1-320 fx (MM) (Central Station 6021x/Mobile Station 60653)
1-511 (DCC)
*mfxnotuntilCS2SoftwareVersion4.0(2ndquarterof2015)

Related product manuals