marklin H0-Oberleitung

Need help?

Do you have a question about the marklin H0-Oberleitung and is the answer not in the manual?

Summary

1. Function

2. Important Information about the Use of the Catenary

3. Setting up

Installing the Catenary Wire on a Mast

Guide to attaching catenary wires to masts for proper setup.

Maximum Deviation of the Catenary Wire

Specifies the allowed side deviation of the catenary wire from the center.

Using the 70231 Catenary Wire Adjustment Section

Instructions on utilizing the 70231 section for wire adjustments.

Installing the Hanger Arm

Procedure for installing the hanger arm onto the mast.

Selection of Catenary Wire Sections on Curves

Guidance on choosing catenary wire lengths for various curve radii.

4. Information about Installation

Working with the 70011 Mast Positioning Jig Set

Using the 70011 jig for accurate mast placement and spacing.

Working with the 70012 Catenary Installation Jig

Utilizing the 70012 jig to check wire offset and pantograph clearance.

Installing a Cross Span

Instructions for installing a cross span over multiple tracks.

5. Planning Examples

Straight Length of Track

Example layout for a straight track section with catenary.

Curve R = 360 mm + 437.5 mm (C Track)

Example layout for a C Track curve with specific radii.

Curve R = 360 mm + 424.6 mm (K Track)

Example layout for a K Track curve with specific radii.

Standard Turnout with Complementary Curve

Layout example for a standard turnout with an adjacent curve.

Two Adjoining Standard Turnouts

Example of two standard turnouts placed next to each other.

Double Slip Switch

Example layout for a double slip switch with catenary.

Curved Turnout

Example layout for a curved turnout with catenary.

Three-Way Turnout

Example layout for a three-way turnout with catenary.

6. Working Catenary

7. Overview of the Catenary Assortiment

8. Examples of Track Plans with Catenary