7
Q Can the leads be cut to length?
A Yes — excessive cable should be coiled and secured if wires are not cut
to length.
Q Is the vibration switch replaceable without having to replace the cable?
A No — the cable is attached with an integrated molded connection. This
connection helps prevent water entry into the switch.
Q Does the probe lead need to be in conduit?
A The sensor cable is rated for outdoor use. Follow local codes to determine
if cable should be placed in conduit.
Integration
Q Can the switch be interfaced with the VFD in the Marley AIO control panel?
A Yes — the Marley AIO panel provides circuits to shut down the VFD and
a status contact used for a remote BMS.
Q Can the switch be interfaced with other equipment such as an
electromechanical motor starter?
A Yes — SPX can provide an interface box.
frequently asked questions
To Next Page
Loading...
Need help?
General
