Preparing for work
Remove the sprayer from the carton
Connect the lance with the feeding valve integrated with handle R020j
Open the cap RP11 and fill in the sprayer with clean water to check the operation of the device
Switch on the button on the control panel and press the trigger on the handle.
If the sprayer works and the battery is sufficiently charged for work then we can start preparing
for spraying
The charge level is displayed on the control panel
In a separate container prepare a liquid according to the recommendations on the packing of
the pesticide
Pour the liquid into a container using the sieve with funnel RP22
NOTE ! After finishing all operations, make sure that the battery is sufficiently charged
to store (store the sprayer with a charged battery), and the sprayer was turned off
using the button on the control panel.
Usage recommendations
Do not store the sprayer in sunlight or in temperatures below +4ºC.
It is not recommended to fill in the tank above the working capacity.
During operation, do not put the sprayer on one side, because instead of liquid the air
can be sucked.
If you observed increased resistance in the feeding valve, lubricate the seals with
silicone lubricant or they can get damaged.
When working with plant protection chemicals, it is necessary to comply with safety
rules, and strictly follow the instructions on the packaging of chemicals.
If you leave some liquid in the lance during winter, expanding ice may damage the valve
and the handle.
To Next Page
Loading...