7
Page
h. Connect the windlass, control unit and power source using electric
cable indicated below. Keep the power supply cable as short as
possible. Too thin and/or too much length of electric cable will
reduce the performance of the windlass or cause the circuit breaker
to work incorrectly.
i. Using foot switches or multiple control switches, a “Remote Control
Box (reversing solenoid) 7-1556” is necessary.
For better performance, we recommend to use “Remote Control Box”
instead of “7-1558” for the 7-1553 & 7-1554 windlasses.
For safety reasons, DO NOT connect the power
source direct to the battery. Please connect the
power cable to the main power switch on your
To Next Page
Loading...