Marquant 014368 - Data Display and Features; Moon Phase and Trend Indicators; Signal Transfer and Data Logging; Outdoor Temperature Warnings

EN
28
signals from the outdoor sensor for
temperature and humidity (- - is shown on
the display), press the DOWN button for
3 seconds to search for the signal
manually. The icon ashes on the display
when the weather station receives signals
from the outdoor sensor.
DISPLAY OF HIGHEST/LOWEST
TEMPERATURE/HUMIDITY
• When the temperature/humidity indoors/
outdoors is shown on the display, and
registering of the highest/lowest values is
started, the highest value Hi and lowest
value Lo are shown.
• The values for highest/lowest
temperature/humidity are automatically
set to zero at 00:00.
IMPORTANT:
• LL,L is shown on the display if the
registered temperature is below the set
limit value. HH,H is shown on the
display if the registered temperature is
over the set limit value.
• LLLL is shown on the display if the
registered barometer pressure is below
the set limit value. HHHH is shown on
the display if the registered barometer
pressure is over the set limit value.
SETTING WARNING FOR OUTDOOR
TEMPERATURE
1. Press the ALERT button for 2 seconds until
the icon for the temperature warning
starts ashing.
2. The icon for upper limit value for
temperature warning starts ashing.
Set the required upper limit for
temperature warning with the UP
and DOWN buttons. Press the ALERT
button to conrm.
3. The icon for lower value for temperature
warning starts ashing. Set the required
lower limit for temperature warning with
the UP and DOWN buttons. Press ALERT to
conrm and close settings mode.
DISPLAY OF MOON PHASES
The weather station shows the phases of the
moon automatically.
A. New moon
B. Waxing half moon
C. Half moon
D. Waxing full moon
E. Full moon
F. Waning full moon
G. Half moon
H. Waning half moon
FIG. 4
DISPLAY OF TEMPERATURE/
HUMIDITY/BAROMETER PRESSURE
AND TRENDS FOR TEMPERATURE/
HUMIDITY
• The actual values for temperature
indoors/humidity indoors/barometer
pressure and trends for temperature/
humidity indoors.
• When a connection is established with the
outdoor sensor the weather station shows
the temperature outdoors/humidity
outdoors and trends for temperature/
humidity outdoors.
• The following indications are given.
Temperature/humidity increasing.
Temperature/humidity constant.
Temperature/humidity decreasing.
SIGNAL TRANSFER
• The weather station starts automatically
receiving signals from the outdoor sensor
for temperature and humidity when the
batteries are inserted.
• When the batteries are inserted the
outdoor sensor for temperature and
humidity automatically sends signals to
the weather station.
• If the weather station does not receive