Marquant 014368 - Manual Settings; Manual Clock Setting; Setting Daily Alarms; Alarm Control

EN
27
after which the clock display image is
shown.
• Choose between 8 display languages
for weekday: English, German, Italian,
French, Russian, Spanish, Dutch and
Danish.
SETTING DAILY ALARMS
1. Press the ALARM button once. The icon
is shown and the settings mode for
alarm is activated.
2. Press the ALARM button for 2 seconds.
The hour value for the alarm starts
ashing. Use the UP and DOWN buttons
to set the hour.
3. Press the ALARM button to conrm.
The minutes value for the alarm starts
ashing. Use the UP and DOWN buttons
to set the minutes.
4. Press the ALARM button to conrm and
close settings mode.
Important information
• The settings mode closes after 20 seconds
if no buttons are pressed, after which the
clock display image is shown.
• The alarm will continue for 2 minutes if it
is not deactivated by pressing a button. In
which case the alarm will repeat
automatically after 24 hours.
• Ascending alarm signal (duration
2 minutes): The volume changes 4 times
during the duration of the alarm signal.
SWITCHING OFF THE ALARM
Press any button other than SNOOZE/LIGHT to
switch o the alarm. The alarm is repeated at
the same time the next day.
SNOOZE MODE
Press the SNOOZE/LIGHT button to activate
snooze mode. The alarm sounds again after
5 minutes.
2. Press the MODE button to conrm.
The unit for temperature starts ashing.
Use the UP and DOWN buttons to select
°C or °F.
3. Press the MODE button to conrm.
The unit for barometer pressure starts
ashing. Use the UP and DOWN buttons
to select mbar/hPa, inHg or mmHg.
4. Press the MODE button to conrm.
The value for time zone starts ashing.
Use the UP and DOWN buttons to select
time zone (-12 to +12).
5. Press the MODE button to conrm.
The hour value starts ashing. Use the
UP and DOWN buttons to set the hour.
6. Press the MODE button to conrm.
The minutes value starts ashing. Use the
UP and DOWN buttons to set the minutes.
7. Press the MODE button to conrm.
The values for month and date start
ashing. Use the UP and DOWN buttons
to select the display format month/day or
day/month.
8. Press the MODE button to conrm.
The year value (2014) starts ashing.
Use the UP and DOWN buttons to set
the year.
9. Press the MODE button to conrm.
The month value starts ashing. Use the
UP and DOWN buttons to set the month.
10. Press the MODE button to conrm.
The date value starts ashing. Press the
up or down button to set the date.
11. Press the MODE button to conrm.
The indicator for language of weekdays
starts ashing. Use the UP and DOWN
buttons to select language.
12. Press MODE to conrm the settings and
exit settings mode. The clock display
image is shown.
IMPORTANT:
• The settings mode closes after
20 seconds if no buttons are pressed,