Owner’s Manual - RG/RADS Series
27
Air Conditioner Features
Air Conditioner
Features
CAUTION
Please always wait 3 minutes when turning unit
ool
to fan and back to cool. This prevents
compressor from overheating & possible circuit
breaker tripping.
WARNING
injury to persons, read the IMPORTANT
SAFETY INSTRUCTIONS before operating
this appliance.
To begin operating the air conditioner,
follow these steps:
1. Set the thermostat to the highest number
(coldest or cooler setting).
2. Set the selector control to the highest COOL
setting.
Air Directional Louvers).
4. Once the room has cooled, adjust the
comfortable.
are not obstructed by anything.
throughout the room as needed.
Move the Levers from side to side until the desired Left/Right
direction is obtained.
Air Directional Louvers
Fresh Air Vent Control (on 10-12 K MODELS)
Lever
Air D irec tion
for 05K, 06K
Levers
Air D irec tion
Levers
Air D irec tion
Air D irection(4- way)
Levers
throughout the room as needed. Pivot horizontal louvers until the desired Up/Down direction is
obtained. Move the Lever(s) from side to side until the desired Left/Right direction is obtained.
The Fresh Air Vent allows the air conditioner to:
1. Recirculate inside air - Vent Closed (See Fig.A)
2. Draw fresh air into the room- Vent Open (see Fig.B)
3. Exchange air from the room and draws fresh air into the room - Vent and Exhaust Open (see Fig.C)
for 06K, 08K, 10K, 12K, 15K, 18K, 25K,28.5K
F ig. A
(VENT CLOSED)
cord.
F ig. B (VENT OPEN)
F ig. C (VENT & EXHAUST OPEN)