Marshall Amplification 1959SLP - Mains Input and Selector; Fuse Management

be set to 8 Ohms. If running into two 8
Ohm cabs, the amp should be set to 4
Ohms.
WARNING: Failure to comply with these
points may result in damage to the amplier.
16. MAINS SELECTOR
WARNING: Your amp should be completely
powered down before the MAINS
SELECTOR is turned.
The MAINS SELECTOR matches the
amplier to the incoming mains voltage.
Ensure that the mains selector is set to
the correct voltage applicable to the
country where the amplier is being
used. If you are unsure of the mains input
voltage contact your authorised Marshall
dealer.
WARNING: Failure to comply with these
points may result in damage to the amplier.
17. MAINS INPUT
Your amp is provided with a detachable
mains (power) lead which connects
here. The specic mains input voltage
rang that your amplier has been built
for is shown on the rear panel. Before
connecng for the rst me, please
ensure that your amplier is compable
with your electricity supply. If you have
any doubt, please get advice from a
qualied person. Your Marshall dealer
will help in this respect.
18. MAINS FUSE
The correct value of mains fuse is
specied on the rear panel of the
amplier.
19. H.T. FUSE
The correct value of H.T. fuse is
specied on the rear panel of the
amplier.
15
16 17 18 19
ENGLISH