Need help?Do you have a question about the Marshall Amplification SE 100 and is the answer not in the manual?
General| Power | 100W |
|---|---|
| Type | Solid State |
| Effects | Reverb |
| EQ | 3-band |
| Controls | Gain, Volume, Bass, Middle, Treble, Reverb |
Overview of the SE100 as a studio quality device for guitarists.
Using the SE100 for studio recording and practice at maximum volume.
Utilizing the SE100 for live performance to control volume and connect to PA.
Details on controls like attenuation, signal/peak LEDs, cabinet type, and level controls.
Connection for amplifier speaker output, routing to multiple outputs.
Connection port for guitar type speaker cabinets.
Input jack for line level equipment, such as guitar pre-amps.
Line level output for processors or as a dummy load.
Filtered output for emulation of amp/speaker sound direct to desks/PA.
Connection for balanced line equipment, e.g., a mixing desk.
Switch to prevent the SE100 causing an earth (ground) loop.
Notes the external 15 volt AC mains adaptor.
Essential safety guidelines and warnings for SE100 usage.
To Next Page