Need help?Do you have a question about the Marshall Amplification 1959HW and is the answer not in the manual?
General| Brand | Marshall Amplification |
|---|---|
| Model | 1959HW |
| Category | Amplifier |
| Language | English |
Information on selecting correct mains voltage settings and matching speaker output impedance to avoid damage.
Step-by-step instructions for safe initial setup, including switch order and control settings.
Safety precautions for moving the amplifier, emphasizing disconnection and proper handling procedures.
Controls the amplifier's on and off state.
Used with the power switch to warm up the amplifier, and for breaks.
Lights up when the amplifier's mains power is switched on.
Adjusts high frequencies of the power amp for added bite.
Adjusts low frequencies for bottom end and depth.
Adjusts mid frequencies for various tonal characteristics.
Adjusts pre-amp upper frequencies for brighter tone.
Controls overall level for channel 1, voiced for higher treble response.
Controls overall level for channel 2, voiced for normal response.
Connects guitar to channel 1 (top/bottom) and channel 2 (top/bottom).
Connect one or two speaker cabinets using 1/4" jack speaker cables.
Matches amplifier output to speaker cabinet load impedance.
Matches amplifier transformer voltage to incoming mains voltage.
Connection point for the supplied mains power lead.
Location for the mains fuse, correct value specified on rear panel.
Location for the H.T. fuse, correct value specified on rear panel.
To Next Page
