Marshall Amplification 1959HW - Front Panel Functions; Power Switch; Standby Switch; Indicator

ENGLISH
4
FRONT PANEL FUNCTIONS
1. POWER SWITCH
Turnstheamponando.
2. STANDBY
Thestandbyswitchisusedinconjunconwith
thepowerswitchto‘warmup’theamplier
beforeuse.
Alwaysturnthepoweronfortwominutes
beforeswitchingthestandbyswitchtothe‘on’
posion.
Thestandbyswitchshouldbesettothe‘o’
posionduringbreaksinperformancesinstead
ofleavingtheamponfullpower.
3. INDICATOR
Thepowerindicatorwilllightwhentheamp’s
mainspowerisswitchedon.
4. PRESENCE
Adjuststhehighfrequenciesofthepoweramp.
Increasingthehighfrequenciesaddsmorebite
toyoursound.
5. BASS
Adjuststhelowfrequenciesoftheamp.Itwill
addboomendanddepthtoyoursound.
6. MIDDLE
Adjuststhemidfrequenciesoftheamp,giving
youanythingfromscoopedmidstoafatand
fullsound.
7. TREBLE
Adjusttheupperfrequenciesofthepre-amp.
Yourtonewillgetbrighterasitisturnedup.
8. HIGH TREBLE - VOLUME I
Controlstheoveralllevelofchannel1.This
channelisvoicedforahighertrebleresponse
thanchannel2.
9. NORMAL - VOLUME II
Controlstheoveralloutputlevelofchannel2.
Channel2isvoicedfornormalresponseand
hasamoreroundedtonethanchannel1.
10. INPUTS
1 (Top): Connectstheguitartochannel1.
1 (Boom): Connectstheguitartothelower
sensivityinputonchannel1.
2 (Top): Connectstheguitartochannel2.
2 (Boom): Connectstheguitartothelower
sensivityinputonchannel2.
Note: someguitarplayersprefertomixthe
twochannelstogetherbyconnecngashort,
screenedpatchleadbetweentheboominput
ofchannel1andthetopinputofchannel2.
Ifyouthenplugyourguitarintothetopinput
ofchannel1,youcanmixthedierenttonal
characteriscsofeachchannelforgreater
exibility.
1 432 5
6
7 8 109