Marshall Amplification CV630-IP - Network Settings Description; Network Connectivity and Access Methods

English - 27
Output Mode
1. 3840 x
2160/29.97p
2. 3840 x 2160/25p
3. 1080p/59.94
4. 1080p/50
5. 1080p/29.97
6. 1080p/25
7. 720p/59.94
8. 720p/50
9. 720p/29.97
10. 720p/25
Choose the output resolution
Factory Reset On / Off
Resume the factory default
setting
Status
Display the current setting
status
English - 28
Chapter 6 Network Function Settings Description
6.1 Connecting Camera to IP Network
6.1.1 Connecting to Internet
Two common connection methods are shown below
1. Connecting via switch or router
2. To connect directly through network cable, the IP address of the computer should
be changed so that it is on the same network segment as the camera
e.g.: The factory-preset default IP address of CV630-IP is 192.168.100.100. The
computer IP address must be set with the same network segment, such as
192.168.100.101, so that the computer can be connected correctly with the camera
● Change network settings
CV630-IP Manual
www.marshall-usa.com27 28