Martela Pinta E - Page 6

19.11.2020 lju
Electrical desks
Resetting and troubleshooting
A400-64176_B
6/6
INSTRUCTIONS
All desks:
Always check that the desk can move freely:
• there is no objects under the desk to prevent it moving to lowest position,
• there is no other obstacles, bulletin board, windowsill, side table corner etc.,
• the length of the cables is enough for the stroke.
Note! Remove all items on desk before resetting. If any of the columns is not moving it may
cause the desk to incline during the reset.
Alku S/S
• If table is not moving check all wire connections and that power is connected.
• If nessesary, disconnect all wires, reconnect again and reset table.
Pinta E:
• If the desk is not moving downwards, although it is not in the lowest position, but it
moves up, the problem is likely in the hand control.
• If the desk is moving downwards but not upwards, perform the reset procedure. If the
desk still does not move upwards, the hand control may be defective.
Pinta EQ:
• If the desk does not work, check that the main switch in the control unit is in position I
(power on).
Pinta III, Pinta EQ:
• If the desk moves upwards when pressing both buttons the hand control switch is
faulty and the reset procedure must be interrupted.
When both buttons are pressed simultaneously, the desk should start moving
downwards within couple of seconds and the buttons should be pressed until the desk
has reached the lowest position. If the reset attempt fails, it can be repeated.
Aura:
• If the desk is not working after reset the reason may be wrong connection of cables
during installation causing errors in control box memory. The control box memory can be
cleared as follows:
• Remove the main plug from socket outlet.
• Press UP and DOWN buttons alternatively for about 15 seconds.
• Reconnect the main plug and perform a reset operation.
If the malfunction can not be solved with these instructions, you can order service.
Non-warranty service is charged according to the valid price list.
You can contact our international team for further information: export@martela.com.