Martin Audio DX2 User Manual

All material © 2007. Martin Audio Ltd. Subject to change without notice.
Loading binary presets into your Martin Audio DX2
Loudspeaker Management System
Clicking here takes you to a zip folder containing the loader software and binary files.
Extract these to your hard disk. Do not run the programme from the zip folder.
Warnings
Loading presets will overwrite previously loaded factory presets - and any
changes to them (e.g. channel gain, delay, limiter settings).
To make a permanent record of changes to the user-editable parts of a preset,
you must save the preset in one of the lower number memory locations.
Make sure you have a full set of .bin files before proceeding so that you can
reload your original presets if you need to.
If you are not familiar with the Martin Audio DX2, please read the DX2
User Guide.
You should have extracted the following files to a suitable folder on your
hard drive:
MartinFlashLoader.exe – The DX2 binary preset loader software
MARTN1RLCDLC21801.bin – Binary presets for
W8LCD+W8LC+WS218X/W8LS combinations
MARTN1RLCDLCWLX01.bin – Binary presets for W8LCD+W8LC+WLX
combinations
MARTN1RLDLBLS02.bin – Binary presets for W8LD+W8L
Longbow+W8LS/WS218X combinations
MARTN1RLM218X03.bin – Binary presets for
W8LMD/LM+WS218S/W8LS combinations
MARTN1RLMWLX03.bin – Binary presets for W8LMD/LM+WLX
combinations
MARTN1RLMWMX03.bin – Binary presets for W8LMD/LM+WMX
combinations
MARTN1RLE12152101.bin – Binary presets for 4-mix LE1200, LE1500
or LE2100 systems

Martin Audio DX2 Specifications

General

Brand	Martin Audio
Model	DX2
Category	Speaker System
Language	English

Summary

Martin Audio DX2 Preset Loading Guide

Important Warnings and Precautions

Critical warnings about data overwriting and saving presets before loading new binary files.

Required Files for Preset Loading

Lists the necessary loader software and binary (.bin) files for the preset loading process.

Step-by-Step Preset Loading Procedure

Connecting Hardware for Preset Loading

Specifies the required serial cable and connection procedure between the computer and the DX2 unit.

Configuring the DX2 for Data Transfer

Guides users through the DX2 menu to set up RS232 mode and other interface parameters.

Using the MartinFlashLoader Application

Details on launching the loader software, selecting preset files, and establishing connection with the DX2.

Selecting and Applying Presets

Instructions on navigating through loaded presets and applying the desired configuration to the DX2.

Amplifier and System Configuration

Amplifier Gain and Limiter Settings

Guidance on setting amplifier gain and adjusting corresponding limiter thresholds for optimal speaker protection.

DX2 Preset and Channel Allocations

Information on preset locking, inter-driver delays, and output channel allocation for system setup.