Martin Audio DX2 - Step-by-Step Preset Loading Procedure; Connecting Hardware for Preset Loading; Configuring the DX2 for Data Transfer; Using the MartinFlashLoader Application

All material © 2007. Martin Audio Ltd. Subject to change without notice.
You will need a 9 pin male-to-female, fully wired, pin-to-pin RS232 cable (not the
null modem type).
To load the latest presets into your DX2
1) Connect the 9-pin male to 9-pin female DEE type serial lead from your
computer to the external socket on the back of the unit. Note: this lead should be
pin-to-pin - not be of the null modem type.
2) On the DX2 use the blue Menu, Back, Next and Enter keys to go into the
Interface Sub-menu and then into External Interface.
3) Once entered, setup as follows:
Mode: RS232 Mode
Wiser Wireless: No
Serial Speed: As required (e.g. 115200)
Stop MIDI Prog,Chng: Yes
Remote ID Number: 1
Press Enter to confirm
4. Run the programme MartinFlashLoader.exe.
Click Load New Preset File.