All material © 2007. Martin Audio Ltd. Subject to change without notice.
If necessary, browse to find the files you extracted earlier. Click on the preset
required (to highlight it) and click Open. The programme will attempt to
communicate with the DX2.
If the Com number (or Speed settings set in 3 above) are not the same as the
DX2 parameters, you will see something like this…
Make sure the Baud rate (Speed) matches the unit to be loaded!
Try adjusting the Com (Serial Port) number and clicking the Connect
button again. It is usually quicker to do this by trial and error as Com port
numbering can be a mystery to the average PC user!
If it succeeds the bottom right hand panel will indicate Good Response.
Click Load Now.
To Next Page
Loading...
Need help?
General
