7
English
Using Speaker Level Inputs
This connection method is recommended if your subwoofer will be
used in a 2-channel only system with full-range front loudspeakers.
To connect using Speaker Level Inputs the speaker cable sshould
be terminated using banana style plugs. The Low-Pass Filter is
applied to the signal received through these inputs.
Speaker Level Inputs are an alternative to using RCA interconnects.
If you use the Speaker Level Inputs do not use RCA at the same
time for Left In/Right In connections. If you use the Speaker Level
Inputs it is okay to still use RCA for the LFE connection.
Connect the left and right outputs of your amplifier to the sub’s
Speaker Level Inputs (Left In/Right In). Use quality speaker cable
and banana plugs. Be consistent and make sure the positive (+)
and negative (–) terminals from your amplifier are attached to the
matching positive (+) and negative (–) terminals on the subwoofer.
If your amplifier only has one set of outputs you may connect your
amplifier to your speakers as normal and run an additional set of
cables from your speakers to the subwoofer’s Speaker Level Inputs.
To Next Page
Loading...
Need help?
General
