4 Try the Phase in different settings until the best blending is
obtained. Play familiar music with deep, repetitive bass. Adjust
the Phase so the bass notes seem their loudest and without blur
when heard from your typical listening position. If you are aug-
menting MartinLogan loudspeakers, we suggest you start with
Phase set at 0°.
5 Use the bass management section of your receiver/proces-
sor’s speaker setup to set the subwoofer level at an appropriate
level. Follow the instructions in your processor’s manual to fine-
tune the subwoofer level.
6 If you have completed steps 1–5 and still have weak or boom-
ing bass, experiment with the settings and listen to the result.
Try to find a position that sounds correct to you. Experiment
by changing the Volume (level). Find a position that gives you
deep extended bass and good blending with your main speak-
ers. If you still have weak or booming bass you may want to
consider moving your subwoofer and go through these setup
steps again (especially if it is located in or near a room cor-
ner). Remember, room position has a major impact on overall
bass performance.
6
English
Dynamo
Subwoofer
Status
Phase
0°
180°
+
Speaker
Level
Input
–
Left In
+
Speaker
Level
Input
–
Right In
Auto
On
Low
Pass
Filter
LFE Out
Receiver/Processor
Figure 5. Signal connection for speaker level inputs.
To Next Page
Loading...
Need help?
General
