MartinLogan Motion Vision - Page 7

7
Note: When installing the system in this configu-
ration, use the soundbar’s menu system to choose
‘INSTAL > ON.WALL’.
Required tools (not included):
• Studfinder
• Level
• Electricdrillanddrillbits
• Phillipsscrewdriver
Required hardware (included):
• (1)Installationtemplate
• (1)Wallbracket
Required hardware (not included):
• (5)Screwsappropriateformountingsurface
• (5)Sheetrockanchors(sizedforscrews)
1 Locate mounting location using a level and the
installation template (fig 1).
2 Mark the three central pilot hole locations and
remove the installation template (fig 1).
3 Using a stud finder, determine if there is a wall
stud directly behind one of the three center
screw locations (fig 2a).
Fig. 1
WARNING! We strongly recom-
mend locating the wall bracket so
at least one of the screw locations
attaches to a stud. WARNING!
To prevent injury, this apparatus must be secure-
ly attached to the floor/wall in accordance
with the installation instructions.