4
Troubleshooting
Problem: Blade speed slow or erratic
Cause: Menu Items 1 or 2 are set too low
Solution: Refer to the Menu Items 1 and 2 in this manual to check
and change the speed settings
Cause: Laser Transmitter is not set on minimum required RPM
Solution: Make sure the Laser is set to at least 600 RPM
Problem: System not responding fast enough
Cause: Laser Transmitter is not set on minimum required RPM
Solution: Make sure the Laser is set to at least 600 RPM
Problem: Mast Speed slow or non-responsive
Cause: Menu Item 3 is set too low
Solution: Refer to the Menu Item 3 in this manual to check and
change the speed setting
Problem: No Lights on Control Panel
Cause: Loose, dirty or damaged cable
Solution: Inspect power cable and connectors for damage or dirt
and make sure it is connected properly. If damaged, call
to order a replacement.
Problem: No signal to Receiver
Cause: Loose, dirty or damaged cable
Solution: Inspect Mast/Receiver cable and connectors for damage
or dirt and make sure it is connected properly. If
damaged, call to order a replacement.
Cause: Laser Transmitter not working properly
Solution: Check to make sure Laser Transmitter is working
properly
Cause: Laser Beam Obstruction
Solution: Make sure nothing is obstructing the laser beam
To Next Page
Loading...