00-13 Precautions:
• Poor terminal-to-wire connection.
Check each wire harness in problem circuits for poor
connection by shaking it by hand lightly. If any
abnormal condition is found, repair or replace.
• Wire insulation which is rubbed through, causing an
intermittent short as the bare area touches other
wiring or parts of the vehicle.
• Wiring broken inside the insulation. This condition
could cause continuity check to show a good circuit,
but if only 1 or 2 strands of a multi-strand-type wire
are intact, resistance could be far too high.
If any abnormality is found, repair or replace.
Special Tools and Equipment
Recommended Service Material
AENAR90A0008001
Special Tool
AENAR90A0008002
I2RH01010059-01
I2RH01010060-01
Material SUZUKI recommended product or Specification Note
Water tight sealant SUZUKI Bond No.1207F P/No.: 99000–31250 )
09916M58210 09917M98221
Valve guide installer handle Valve guide stem
attachment
))
To Next Page
Loading...
Need help?
General
