INSTALLING THE WATER SUPPLY
Based upon the TDS measurement, see the below table
to determine the correct lter required to protect the ice
machine.
Water Quality 1-3 Users 4+ Users
200 TDS and/or
12 gpg hardness
or less
Required
Standard Filter
Change 1x per
year
Required
Large Filter
Change 1x per
year
201-400 TDS and/
or 12-19 gpg hard-
ness
Required
Large Filter
Change 1x per
year
Required
Large Filter
Change 2x per
year
400+ TDS, and/or
20+ gpg hardness
Contact your local water professional
• The water pressure should be between 20 and 120 psi
(138 and 827 kPa).
• The water line MUST have a shut-o valve in the
supply line.
• The water line should be looped into 2 coils. This will
allow the unit to be removed for cleaning and servicing.
Make certain that the tubing is not pinched or damaged
during installation.
Do not use any plastic water supply line. The line is under
pressure at all times. Plastic may crack or rupture with age
and cause damage to your home.
Do not use tape or joint compound when attaching a
braided exible water supply line that includes a rubber
gasket. The gasket provides an adequate seal – other
materials could cause blockage of the valve.
Failure to follow recommendations and instructions may
result in damage and/or harm, ooding or void the product
warranty.
Use new hose set. Do not reuse old hose set.
Turn o water supply and disconnect electrical supply to
unit prior to installation.
Use caution when handling back panel. The edges could
be sharp.
Water Hookup
1. Turn o water supply and disconnect electrical supply
to product prior to attempting installation.
2. Remove the back panel.
3. Thread water line through back panel hole (with
bushing).
4. Locate water valve inlet and connect to valve.
5. Turn on water supply and check for leaks.
6. Reinstall back panel.
!
CAUTION
!
CAUTION
4
13
To Next Page
Loading...
