pin is correctly entered. Enter the new 4 digit pin. Use (C) button to correct wrong entries.
Once the new pin is written press button. “Saving” will be visible at the panel screen and
the new pin is set.
1.6.9. Extra camera
Enter System Settings Menu (Refer to 1.6). Press button on the menu “9-Extra camera”.
“EXTRA CAMERA / PANEL” will be displayed. If you will use as “>>KAM08<<” the extra
camera mode which was preset as “>>PANEL<<” at the factory, you have to set it as
“>>KAM08<<”. To change the settings, use and buttons. To save the new settings,
press and make sure that “SAVING” is displayed on the screen.
1.6.10 Back to Factory Settings
Enter System Settings Menu (Refer to 1.6). Press button on the menu: Back to Factory
Settings.”Are you sure ?” will be visible at panel screen. Press button. “ Back to Factory
settings” will be visible at the panel screen with the progress bar. Once the progress bar
shows 100 %, settings are adjusted to factory values.
Parameter Initial value Parameter Initial value
Settings password “0000” ABS-1 90 sec.
Door common
password “1234” ABS-2 180 sec.
Number of
appartments “380” EAS-2 20 sec.
Active language 01->TURKISH
Connection
channel
App. 1-
Doorkeeper 1
Number of door
pass 0
Welcome screen
1st. Line
"MAS
INTERCOM"
Guard flat number “995”
Welcome screen
2nd. Line “:)---------(:”
First flat number 1 Apt. passwords Off
Door open time 1 sec. System password
1597
TABLE 2 : Initial values after reset to factory values
1.6.11 Delete all names in the name list
Enter System Settings Menu (Refer to 1.6). Press button on the menu: “Delete All names
in the name list”. ”Are you sure to delete all names in the name list?” will be visible at panel
screen. Press button.” Deleting name list” will be visiible at the panel screen with the
progress bar. Once the progress bar shows 100 %, all names will be deleted.
1.6.12 Delete all cards “All cards identified in the panel” (Optional, if card Access is
available)
Enter System Settings Menu (Refer to 1.6). Press button on the menu: “Delete All
Cards”. ”Deleting cards” will be visible at the panel screen.Approximately in 5 seconds, all
cards will be deleted and “ALL CARDS DELETED” will appear on the screen.
To Next Page
Loading...