1.6.1 Change number of apartments
Enter System Settings Menu (Refer to 1.6). Press button on the menu: Change number
of Apartments. “Enter Apartment Number” will be visibile at the panel screen.Enter the
Apartment number using the panel than press button.”Saving” will be visible at the
screen and the number of Apartments will be changed.
1.6.2 Define first Apartment number (not yet active)
Enter System Settings Menu (Refer to 1.6). Press button on the menu: Define first
Apartment number “Enter First Apartment Number” will be visibile at the panel screen.Enter
the first Apartment number using the panel than press button.”Saving” will be visible at
the screen and the first Apartment number will be changed.
1.6.3 Define guard number
This feature is not yet active.
1.6.4 Set language
Enter System Settings Menu (Refer to 1.6). Press button on the menu: Set language.
“Language Setting <01 Turkish> will be visible at th panel screen. Change the language
setting by scrolling down & up using and . Press button. ”Saving” will be
visible at the screen and the panel language will be changed.
1.6.5 Assign block number
Enter System Settings Menu (Refer to 1.6). Press button on the menu: Assign block
number. “Enter Block Number” will be visibile at the panel screen. Enter the block number
using the panel than press button.”Saving” will be visible at the screen and the number
of blocks will be changed.
1.6.6 Change EFES System Settings
Enter System Settings Menu (Refer to 1.6). Press button on the menu: Change EFES
System Settings. Pressing (#) button scroll through "ANTIBLOCK TIME-1", "ANTIBLOCK
TIME-2", "SCREEN OPEN TIME1", "SCREEN OPEN TIME2","SCREEN ON/OFF" and
"CONNECTION CHANNEL" parameters and the respective values. Press button to
change the value of time parameters. Enter the time parameters in multiples of 10 sec. Press
button to save the new value. “Saving” should be visible at the panel screen. Press
button to change the setting of "SCREEN ON/OFF" and "CONNECTION CHANNEL"
parameters than select from the 4 different setting mode using and buttons. Press
button to save the new setting. “Saving” should be visible at the panel screen.
1.6.7 Programming monitors in Apartments
Enter System Settings Menu (Refer to 1.6). Press button on the menu “Change
Apartment Program”. “Apt. unit will be programmed. Are you sure??” will be visible at the
panel screen. Press button to program Apartment units based on saved parameters at the
panel. Press (C) button to exit.
1.6.8 Change System Setting Pin
Enter System Settings Menu (Refer to 1.6). Press button on the menu “8- Change
System Setting Pin”. “Enter System Pin” will be visible at the panel screen. Enter the 4-digit
system setting pin than press
button. .”New pin” will be visible at the panel screen if the
To Next Page
Loading...