NOTE:
Due to the difficulty of this operation,
we recommend that you contact the
Service Network for replacement of
the blades.
Rear Window Blade Replacement
• To replace the rear window wiper
blade on the liftgate, lift the wiper
arm with blade up to the stop
position.
• Turn the blade to the position
indicated in the figure.
• Hold the arm steady and pull the
blade, by holding it from the central
support, until it is removed.
• Replace the blade.
• Insert the pivot, present inside the
blade central support, in the
fork-shaped end of the arm until
hearing the click indicating that it is
engaged.
Stretch the arm and put the blade
back in contact with the liftgate
window.
Body Lubrication
Locks and all body pivot points,
including such items as seat tracks,
door hinge pivot points and rollers,
liftgate, sliding parts of power sunroof
(if foreseen) and hood hinges, should
be lubricated periodically with a
lithium-based grease. This action is
essential to preserve the original
operation of these components and to
protect them against rust and wear.
Prior to the application of any
lubricant, the parts concerned should
be wiped clean to remove dust and
grit; after lubricating excess oil and
grease should be removed. Particular
attention should also be given to hood
latching components to ensure proper
function. When performing
maintenance in the engine
compartment, the hood latch, release
mechanism and safety catch should be
cleaned and lubricated. The coupling
pin of the lock on the rear driver door
pillar must be lubricated at least twice
a year, preferably in the Fall and
Spring. Apply a small amount of high
quality lubricant directly on the bolt.
Maintenance and Care
7
358
To Next Page
Loading...
